Tabla de contenido
Publicidad
Step 11
Carefully stand your unit upright.
å
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40NA) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
å
holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagrams. Then, slide the inner cartridge
å
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Open end
1
Open end
www.sauder.com/services
40NC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
4
3
2
3
2
1
3S
B
4
422593
40NA
A
Page 15
Publicidad
Tabla de contenido
