Hinge; Black 1" Pan Head Screw - Sauder Dakota Pass 422593 Folleto De Instrucciones

Step 15
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the hinge diagram. If it
isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
Fasten the DOOR (F) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten the DOOR MOLDING (O) to the DOOR (F). Use two
å
BLACK 1" PAN HEAD SCREWS (60S).
Fasten a KNOB (5K) to the DOOR (F). Use a SILVER 1-1/2"
å
MACHINE SCREW (95S) through the DOOR, through the DOOR
MOLDING (O), and into the KNOB.
Push the DOOR STOP (4I) into the hole in the RIGHT END (A).
å
See the next step for DOOR adjustments.
å
SILVER 1-1/2" MACHINE SCREW
(1 used for the KNOB)
www.sauder.com/services
60S

BLACK 1" PAN HEAD SCREW

(2 used for the DOOR MOLDING)
5K
O
95S
B
F
4I
422593
Stop
Mounting
screw

Hinge

A
Page 19