Maintenance Table V (Hs, Hp) Series, Part 2 Of - GEA Grasso V Manual De Instalación Y Mantenimiento

MANTENIMIENTO
ESQUEMA DE MANTENIMIENTO Y SERVICIO

3.4.3.2 Maintenance table V (HS, HP) Series, part 2 of 3

GEA Grasso Maintenance intervals, part 2 of 3
GEA GRASSO MAINTENANCE INTERVALS AND ACTIVITIES
Main system Sub system
CYLINDER LINERS
Note: For A maintenance keep inspection limited to 1 or 2 most frequently activated cylinders or cylinder(s)
nearest to the compressor's shaft end. Refer Sección 3.4.3.4, Página 51
Piston assembly
PISTON & CONNEC-
TING ROD
ASSEMBLY Connecting rod assembly
Note: For B maintenance keep inspection limited to 1 or 2 most frequently activated cylinders or cylinder(s)
nearest to the compressor's shaft end. Refer Sección 3.4.3.4, Página 51
MAIN BEARINGS
CRANKSHAFT
50
Mechanical part
Inner surface honing profile
2)
Suction valve seats
Push rods suc. valves capa-
city regulation / lifting mecha-
nism
Camring
Piston body
Piston rings
Gudgeon pin
Small end bearing bushing
Tightening conn.rod bolts &
nuts
Big end bearing shells
Main bearing oil pump side
Intermediate bearings
Main bearing drive side
Main bearing journals
Conn.rod bearing journals
Shaft seal journal
Trust bearing
Shaft seal
Flexible:
Depending on running con-
ditions and shown by GMM
or OMNI
- - - - - - - - - -
Fixed:
To be monitored by opera-
Whatever
comes first:
Flexible
Yearly or
interval:
every
VM 6.000 -
6.000 hr at
18.000 hr
1200 RPM
VL 7.500 -
5.000 hr at
18.000 hr
1500 RPM
Fixed inter-
val:
12.000 hr at
1200 RPM
- - - - -
10.000 hr at
1500 RPM
A B
INSPECT MEASURE
INSPECT
INSPECT
INSPECT
INSPECT
INSPECT
INSPECT
INSPECT
INSPECT INSPECT
0089588_imm_v_spanish_~_20
tor
Flexible
interval:
VM 40.000 –
47.000 hr
VL 40.000 –
54.000 hr
Fixed inter-
val:
36.000 hr at
1200 RPM
- - - - -
30.000 hr at
1500 RPM
C
MEASURE
INSPECT
INSPECT
INSPECT
INSPECT
REPLACE
MEASURE
MEASURE
REPLACE
INSPECT
INSPECT
INSPECT
MEASURE
MEASURE
INSPECT
INSPECT
REPLACE
26.07.2021