Product Safety Information; Product Specifications - Ingersoll Rand Air Impact Wrench 588A1 Manual De Instrucciones

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners requiring high
torque.
● Failure to observe the following warnings, and to avoid these potentially hazardous
situations, could result in death or serious injury.
● This tool is designed to be operated by a minimum of two persons.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrand.com

Product Specifications

Drive
Model
Type in.
588A1
Square 2-1/2"
588A1-EU
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K= Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16606303 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
03523107_ed17
WARNING
Recommended
Impacts
Torque Range
per min.
ft-lb (Nm)
12000-25000
550
(16270-33900)
WARNING
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p
110.0 121.0
7. Coupling
8. Safety Air Fuse
9. Oil
10. Oil - fill oil chamber
11. Grease - through fitting
12. Grease - through fitting
EN
Vibration (m/s²)
(ISO28927)
) Level *K
w
-- --
EN-1