Operation - Husky HU80220 Manual Del Operador

WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Do not direct discharge stream at persons. Failure to heed
this warning could result in serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Removing dirt and mold from decks, cement patios, and
house siding
 Cleaning cars, boats, motorcycles, outdoor furniture, and
grills
CAUTION:
Always observe all local regulations when connnecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
All manuals and user guides at all-guides.com

OPERATION

ADDING DETERGENT TO THE PRESSURE
WASHER
See Figure 9.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.
 Disconnect pressure washer from power supply.
 Place pressure washer upright on a flat surface.
 Remove cap from detergent tank.
 Pour detergent into tank until it reaches the maximum fill
 Reinstall cap.
STARTING AND STOPPING THE PRESSURE
WASHER
See Figure 10.
 Connect the garden hose.
 Turn the garden hose on then squeeze the high pressure
 After ensuring the switch is in the OFF position, connect
 Press the reset button on the pressure washer's plug to
 Press ON ( I ) on the switch to start the motor.
 To stop the motor, release the trigger and press OFF
10 — English
level located on the unit.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any detergent
is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
CAUTION:
Do not run the pump without the water supply connected
and turned on.
trigger to relieve air pressure. Once a steady stream of
water appears, release the trigger.
the pressure washer to the power supply.
make sure the unit is ready for operation.
( o ) on the switch.
WARNING
:
Hold the handle and wand securely with both hands. Ex-
pect the trigger handle to move when the trigger is pulled
due to reaction forces. Failure to do so could cause loss
of control and injury to yourself and others.