Unpacking; Assembly - Husky HU80220 Manual Del Operador

HIGH PRESSURE TRIGGER LOCK-OUT
The trigger lock-out prevents accidental use of the high-
pressure trigger.
HyDRoSURGE/LoW pRESSURE (HIGH FLoW)
LEVER
Use this lever when you want to dispense water alone or a
combination of water and detergent at low pressure.

UNPACKING

This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.
PACKING LIST
Electric Pressure Washer and Hose
Handle Assembly
Spray Wand
Wheels (2)
Axles (2)
Hitch Pins (2)
Washers (2)
Nozzles (2)
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
All manuals and user guides at all-guides.com
FEATURES
ON/OFF SWITCH
This switch turns the pressure washer on and off.
TELESCOPING HANDLE
The telescoping handle allows the handle to be lowered for
convenient storage.
SPRAY WAND
The spray wand features two outlets — one for high pressure
spray and one for low pressure (high flow) spray.

ASSEMBLY

INSTALLING THE WHEELS
See Figure 4.
 Locate the axles, hitch pins, washers, and wheels.
 Slide the axle through the hole in the center of the
 Lift the machine and slide the axle into the wheel mount-
 Slide the washer on the axle, then push the hitch pin
 Repeat with the second wheel.
ATTACHING THE HANDLE ASSEMBLY
See Figure 5.
 Orient the handle assembly as shown.
 Depress the button on the handle assembly and insert
 Lower both collars on the handle and rotate clockwise
8 — English
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
wheel.
ing hole in the machine base as shown.
into the hole on the end of the axle to secure the wheel
assembly.
NOTE: The hitch pin should be pushed into the axle until
the center of the pin rests on top of the axle.
into the holes on the pressure washer. Press down on the
handle assembly until the button on the handle clicks into
place.
until secure.