Step 4 - Setting The Zone And Stereo Switches - Ebode LightSpeaker El Manual Del Propietario

All manuals and user guides at all-guides.com
Step 4: Setting the Zone and L/R Stereo Switches.
A) Set the zone switch on the back of the
LightSpeakers
two zone system. For more on zones see Step 4B:
Setting up a Two Zone System below after completing
B and C below.
B) Set the left/right stereo switch. "L" if it is the left
speaker, "R" if it is the right speaker.
C) Your LightSpeaker
to 4 pairs of (or 8 total) speakers. If you are installing
more than one pair of LightSpeakers
probably want to divide your home into zones.
If you are not setting up a two zone system, go to Step 5.
Step 4B: Setting up a Two Zone System
Your system allows you to set up two separate zones.
Zones are the different spaces in your home where you
want to listen to music, and are important because, later in
this setup, your Transmitter will automatically seek out and
identify each zone. This in turn will allow you to control the
music and lighting in each zone separately.
® to one, unless you are setting up a
®
system allows you to install up
®
you will
11