All manuals and user guides at all-guides.com
Operating the Transmitter and Remote Control:
The remote control and
the transmitter are
controlled in exactly the
same manner.
When you push a button
on the transmitter the
small LED next to the
button will light up and remain lit until you push another
button affecting either that zone or that source. The
LEDs that are lit will tell what action the remote or
transmitter is currently set to control.
Here are the steps to take to operate the Transmitter
and Remote Control:
A) Press the zone you want to control
B) When the LED next to the button lights, that zone
is active and will be playing the source that is currently
lit. To change to a different source simply press the
source with the "unlit" LED until the LED next to the
source you are choosing lights.
C) Pressing Light once makes the light go On/Off
D) Pressing the + arrow above the light "on" button
will increase the brightness of the light. Pressing the
"-" arrow below the light on/off button will dim the
light. The LED will flash when the arrows are pushed
and will turn red and flash quickly when either the
maximum or minimum brightness is reached.
17