Uline H-6513 Manual Del Usuario página 4

1. Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3. Slide wheel onto axle and hold in place with axle
nuts. (See Figure 1)
Wheel
Support
Frame
Wheel
Axle
Nut
NOTE: Do not tighten nuts fully. You will need to
remove the wheels in a later step.
4. Place heater on wheel support frame and line up
holes on the fuel tank lip.
5. Attach front handle with two 50 mm screws and two
nuts through the second hole from the front on both
sides of the tank lip and wheel support frame and
tighten firmly.
6. Insert two 30 mm screws through the first hole from the
front in the tank lip and tighten firmly. Make certain all
four screws are secure.
PAGE 4 OF 27
ASSEMBLY
Figure 1
Axle
Spacer
7. Attach rear handle with two 50 mm screws and two
nuts through the third hole from the rear of the heater
on either side. (See Figure 2)
Tank Lip
Wheel Support Frame
NOTE: You will secure the rear handle in step 10.
8. Check that the tank does not contain fuel. If the tank
is empty, gently tilt the heater so it is resting on the
front handle. (See Figure 3)
NOTE: Do not tilt heater if tank contains fuel.
9. Remove the wheels to secure the second set of
screws through the rear handle.
10. Secure the rear handle with two 30 mm screws and
two nuts and tighten firmly.
11. Replace wheels and tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check all
screws and nuts to make sure they are secure.
Front Handle
Rear Handle
Unused Hole
Figure 2
Figure 3
0521 IH-6513