Long Term Storage - Uline H-6513 Manual Del Usuario

LONG TERM STORAGE

1. Drain fuel through the drain plug in the bottom of
the fuel tank.
2. To remove the drain plug, pull the plug grip
downward and remove the seal head from the drain
hole in the tank. (See Figures 5 and 6)
Drain Plug
3. Using a small amount of kerosene, rinse and swirl the
kerosene inside of the fuel tank and empty the tank
fully.
4. To replace the drain plug, push the drain head fully
into the drain hole and secure by pushing the seal
cap fully into the head hole. (See Figure 6)
Fuel Tank
Head Flange
IMPORTANT! Never store leftover kerosene
between seasons, as using old fuel can
damage heater.
SERVICE
WARNING! Never service heater while it is
plugged in or hot.
Do not tamper with the unit. Have a competent
serviceman make any necessary adjustment
or repairs.
Use only original equipment manufacturer parts. The
use of alternate or third party components can cause
unsafe operating conditions and will void your warranty.
NOTE: To order parts, call Uline Customer
Service at 1-800-295-5510.
PAGE 6 OF 27
Figure 5
Drain Plug
Grip
Drain Plug
Seal Head
Seal Cap
MAINTENANCE
Follow a maintenance schedule as follows:
FUEL/FUEL TANK
Flush tank every 200 hours of operation as needed.
NOTE: Follow the long term storage instructions
to flush the tank.
Do not flush with water, use fresh 1-K kerosene only.
AIR FILTERS
The air intake filter should be replaced or washed with
soap and water and dried thoroughly every 500 hours
of operation or less depending on conditions.
(See Figure 7)
The output and lint filters should be replaced every 500
hours of operation, or less depending on conditions.
(See Figure 7)
NOTE: Use of diesel fuel may require additional
maintenance.
Figure 6
FAN BLADES
Blades should be cleaned at least once per heating
season, depending on conditions. Remove all
accumulated dust and dirt with a damp cloth, taking care
not to bend any of the fan blades. Be sure the blades
are dry before restarting the heater. (See Figure 8)
End Filter
Lint Filter
Set Screw
Motor
Shaft
Fan Blade
Figure 7
Air Output
Filter
Intake
Filter
Figure 8
0521 IH-6513