Replacement Parts; Troubleshooting - Marshalltown Bullet 526-RCT26 Manual De Instrucciones

REPLACEMENT REPLACEMENT
EDI
29796
29860 847-RP
29877 858-RP-EZFLR
29880 858-RP-L200
29881 858-RP-U009
29906 868-RP-EZ
29874 856AG-26
29901 865-220-RP
29857 845-RP-R26
29885 860-RP-CML
29893 862-RP-220
29897 863-RP-EZ50
29898 863-RP-EZ80
29889 861-RP0526
29909 869-RP-526
29853 822-RP-526
Replacement parts are available at www.marshalltown.com – search for the Replacement EDI as listed above.
Before troubleshooting double-check the manual:
• Is your shear properly assembled?
• Is it being operated correctly?
• Is it properly lubricated?
• Has the blade been honed as recommended?
Visually inspect shear, watching for objects that might obstruct the blade or powerhead travel:
• Foreign material presence between the blade and anvil, in the pin springs or under the cam.
• Check your blade for chips, cracks or burrs.
• Make sure bearings are intact and lubricated. They should not be spinning/moving on the cam during use.
NOTE: This troubleshooting is for all Bullet shears. If you are uncertain if it pertains to your shear, please contact
Marshalltown customer service.
12 of 14
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

REPLACEMENT PARTS

PART#
526B
REPLACEMENT HANDLE SPRING PIN, 5/16" 1 SIDED
REPLACEMENT BEARING SET, 526, 213-SST
REPLACEMENT RAIL SET FOR 526 (4/SET)
REPLACEMENT HANDLE ATTACH BOLTS,
REPLACEMENT 10MM X 80MM AXLE BOLT

TROUBLESHOOTING

DESCRIPTION
REPLACEMENT BLADE, 526/126
REPLACEMENT HANDLE ASSEMBLY
REPLACEMENT HANDLE LOWER ONLY
REPLACEMENT HANDLE UPPER ONLY
REPLACEMENT HANDLE GRIP ONLY
ANGLE GUIDE KIT -26"
REPLACEMENT CAMLOCK PIN & CHAIN
REPLACEMENT PINS (2EA),
213-SID / 220 SINGLE CAM / 526
F BEAM EZ SHEAR
REPLACEMENT CAMSHAFT, 526
(BEARINGS NOT INCLUDED)
REPLACEMENT BLADE STOP 526/126
REPLACEMENT TABLE, 526
INCLUDES
DETAIL #'S
22
14
3, 5,10, 12, 18
3
5,10,12
12
24, 25, 26, 27, 28,
29
33
4
6
8,32
18 (partial)
7
1
17
15
WS2638