Satco NUVO S11829 Instrucciones De Instalación Y Seguridad

LED EDGE LIT 4", 6" & 8"
SQUARE RECESSED DOWNLIGHTS
Models: S11829, S11830, S11831
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any maintenance of the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the fixture
or replace accessories without confirming with the supplier first.
• Only authorized, qualified personnel should install this fixture and
should follow the owner's manual.
• Do not dismantle the fixture without the supplier's authorization.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive
dust on the fixture may be expected.
• Suitable for indoor/outdoor installations.
IMPORTANT:
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product and the
hazards involved.
Model Dimensions
S11829 4 inches
S11830 6 inches
S11831 8 inches
INSTALLATION
TOOLS REQUIRED: Hole saw, measuring tape and connector cables (as needed).
NOTE: Use extensions if necessary. Available connector cables are 6' (1.8m).
Connector cables are linkable.
1. Turn power OFF from the electrical panel before starting installation.
2. Cut a hole in the ceiling for the downlight in a suitable position. Refer to Hole Cut
Dimension chart (below).
3. Run the electrical wire from the switch (power supply wire) through the mounting hole.
Use NMD90 Romex or BX cable. See Figure A.
4. Open the Junction Box swing cover and remove the appropriate knockouts.
5. Insert the power supply wire through the knockout and fasten with a cable connector
(not included).
6. Connect wires inside the Junction Box using the quick connect terminals. Connect
green ground with the green box wire. Connect the black and white power leads with the
matching black and white box wires. See Wiring Diagram.
7. Put all wires and connections back into the box and close the cover securely.
8. New Construction Applications: Junction Box shall be firmly secured to the studs,
joists or similar fixed structural units.
Remodel Applications: Do not require the Junction Box to be firmly secured to fixed
structural units. Remove the Junction Box tabs, then insert into ceiling.
9. Choose desired color temperature. See figure B.
10. Bend back the two torsion springs and slowly fit the fixture through the ceiling hole.
The torsion springs will pull the fixture into place. See Figures C & D.
11. Once installation is complete, turn power ON to confirm the fixture is working properly.
Hole Cut Dimensions:
4" fixture = ø 4 3/16" (106mm)
6" fixture = ø 6 3/16" (157mm)
8" fixture = ø 8 3/16" (208mm)
© Copyright 2020 Satco Products, Inc. 6/20
Watts Volts CCT
10W 27K,30K,35K,40K,50K
12W 120V 27K,30K,35K,40K,50K
24W 27K,30K,35K,40K,50K
WIRING DIAGRAM
Power supply
CRI Finish
90 White
Fixture Includes:
1 LED Lamp
1 Junction Box
Quick connect
Black wires
terminals
White wires
Green wires
Cable to fixture
Satco Products, Inc.
Brentwood, NY 11717