Satco NUVO S11846 Manual De Instalación

5/6" DOWNLIGHT RETROFIT
WITH NIGHTLIGHT
Model: S11846
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• THIS DEVICE IS NOT INTENDED FOR USE WITH
EMERGENCY EXITS.
• Please examine all parts that are not intended to be replaced
by the retrofit kit for damage and replace any damaged parts
prior to installation of the retrofit kit.
• The retrofit kit is accepted as a component of a luminaire
where the suitability of the combination shall be determined
by authorities having jurisdiction. Product must be installed
by a qualified electrician in accordance with the applicable
and appropriate electrical codes. The installation guide does
not supersede local or national regulations for electrical
installations.
• LED Retrofit Kit installation requires knowledge of luminaries
electrical systems. If not qualified, do not attempt installation.
Contact a qualified electrician.
• To reduce risk of fire and over-heating, secure all connections
are tight.
• TURN OFF the electrical power before proceeding.
• To prevent wiring damage or abrasion, do not expose wiring to
edges of sheet metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring
or electrical components during kit installation.
• Dimming range: 10%-100%
WARRANTY: This product is guaranteed for a 5 year warranty. Any quality issue in normal use within the warranty
period, will be repaired or replaced according to the situation and under the condition specifications can be provided.
Visit www.Satco.com for full warranty details and dimmer compatibility information.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
© Copyright 2022 Satco Products, Inc. 1/23 v1.3
3.17"
(80.6 ± 2mm)
Nightlight Feature Operation
1. To activate nightlight mode, switch the
downlight off and back on again.
2. To return to downlight mode, switch the
downlight off and back on again.
1
S11846
7.40"
(Ø188 ± 2mm)
Min: 5 3/4"
(146mm)
Min: 5 3/8"
ø
( 136mm)
Satco Products, Inc.
Brentwood, NY 11717