Satco NUVO S11832 Instrucciones De Instalación Y Seguridad

4" LED
DOWNLIGHT RETROFIT
Model: S11832 S11833 S11834
INSTALLATION AND SAFETY INSTRUCTIONS
WARNING:
Risk of Fire or Electric Shock
• LED Retro t Kit installation requires knowledge of luminaries electrical systems. If not
quali ed, do not attempt installation. Contact a quali ed electrician.
• To reduce risk of re and over-heating, secure all connections are tight.
• TURN OFF the electrical power before proceeding.
• Install this kit only in luminaires that have the construction features and dimensions
shown in the photographs and/or drawings and where the input rating of the retro t kit
does not exceed the input rating of the luminaire.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or electrical components
during kit installation.
THE RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE
•
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY AUTHORITIES HAVING
JURISDICTION. PRODUCT MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN
ACCORDANCE WITH THE APPLICABLE AND APPROPRIATE ELECTRICAL CODES. THE
INSTALLATION GUIDE DOES NOT SUPERSEDE LOCAL OR NATIONAL REGULATIONS
FOR ELECTRICAL INSTALLATIONS.
• THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS.
• Please examine all parts that are not intended to be replaced by the retro t kit for damage
and replace any damaged parts prior to installation of the retro t kit.
WARRANTY
:
This product is guaranteed for a 5 year warranty. Any quality issue in normal
use within the warranty period, will be repaired or replaced according to the situation and under
dimmer compatibility information.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
NOTE 2:
could void the user's authority to operate the equipment.
INSTALLATION:
1
Turn off power prior to installation.
Remove the diffuser and existing bulb
if necessary. Remove the existing trim.
4
Connect the quick
disconnect between
the medium base
umbilical socket.
© Copyright 2019 Satco Products, Inc. 6/19
2
Before installation, select your preferred
CCT by moving the switch to either
2700K, 3000K, 3500K, 4000K or 5000K.
5
Slide the LED
Downlight up into the
recessed housing
with the ceiling.
Dimensions:
3
2700K
3000K
3500K
4000K
5000K
Twist the lamp base into
the lamp holder.
6
with the ceiling surface. Turn on power.
4.06
Satco Products, Inc.
Brentwood, NY 11717