Mounting The Antenna - Revell Control FARM TRACTOR PLUS Manual Del Usuario

4 STarT preparaTIoN
First move the switch on the rear side of
the remote control to ON (4A), then set
the switch on the underside of the model
(4B) to ON. When switching off, always
switch off the vehicle first (cf.4B)! And
after it the remote control (cf.4A).
Otherwise, a drive command can
accidentally be triggered, causing the
vehicle to drive away on its own, which
can lead to considerable damage.
6 vehICle CoNTrol
6A In order to drive forwards, push the
lever for forward and reverse travel
on the left side of the remote control
forwards.
6B In order to drive backwards, push the le-
ver for forward and reverse travel on the
left side of the remote control back-
wards. The model stops instantly after
the lever is released.
6C In order to drive along curves, move
the steering wheel in the centre of the
remote control in the corresponding
direction.

7 MouNTINg The aNTeNNa

The accompanying antenna must be mounted on the remote control. For this purpose,
guide the end of the antenna to the thread on the upper side of the remote control
and turn clockwise until hand­tight. The range of the model is significantly decreased
without the antenna.
8 CoNNeCTINg The TraIler
8A To attach the trailer, the lock of the clutch must first be lifted slightly and then
folded back again.
8B That way, the ball folds down again and the drawbar can be guided in easily.
8C Raise the lever of the trailer coupling and slide it forward to lock the trailer on
8D The insert the trailer power plug into the power outlet of the tractor
12
5 STeerINg TrIM adjuSTMeNT
The correct trim is a basic requirement
for fault-free driving behaviour from the
vehicle. Adjusting the trim is easy, but it
requires a little patience and a feel for it.
Please follow the following
instructions precisely:
If the vehicle pulls to the left or the
right without being steered...
use the trim lever to correct the wheel
alignment by turning it in the opposite
direction. The wheel alignment can be found
on the bottom of the vehicle (cf. 5).
6D The dump body of the trailer can be
raised or lowered with the two left
and right levers on the upper side of
the remote control. A soft clatter of
the slip clutch can be heard at the top
and bottom limit position. This is com-
pletely normal.
6E With the right-hand lever on the remote
control, the front bucket of the tractor
can be raised and lowered. A soft clatter
of the slip clutch can be heard at the top
and bottom limit positiv.This is comple-
tely normal.
INSTruCTIoNS For SaFe drIvINg
GENERAL DRIVING TIpS:
• Always maintain visual contact with the vehicle and do not look at the remote control!
• On initial driving attempts, there is a general tendency toward excessive movements
of the controls. Make sure that you have sufficient room.
After a crash, always release the speed control immediately in order to prevent dama-
ge to the electronics.
THE SuITABLE DRIVING ENVIRONMENT:
The location in which the vehicle is driven should fulfill the following criteria:
1. It should be a location in which there is as much open area as possible, without
disruptive obstacles.
2. Make absolutely sure when starting that there are no people or animals in the
immediate vicinity.
3. Always watch the vehicle so that it does not drive into the operator, other people or
animals and injuries them.
TrouBleShooTINg
problem: The vehicle does not move.
Cause: • The batteries are too weak and/or depleted.
Remedy: • The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
• Please replace with new batteries.
problem: Remote control does not work.
Cause: • The remote control is switched off.
• The batteries were not inserted correctly.
• The batteries do not have enough power.
Remedy: • Repeat the switch-on process as described.
• Check whether the batteries are inserted correctly.
• Please replace with new batteries.
problem: The vehicle cannot be controlled with the remote control.
Cause: • The remote control is switched off
• The connection between the remote control and vehicle has been severed.
Remedy: • Move the remote control switch to the "ON" position.
• When the model is further than 5 metres away, move towards the model
Additional tips and trick can be found online at www.revellutions.de.
ServICe NoTeS
You can find ordering options, the online game and
useful information for all Revellutions models at
www.revellutions.de.
www.revellutions.de
13