Software Configurations; Lan Connection - AERMEC AER Connect Manual De Instrucciones

3

SOFTWARE CONFIGURATIONS

3.1 CONFIGURATION OF THE MGATE MODULE
Before moving on to the MGate module configuration, analyse how the converter is connected to the PC which will be used for the following configuration steps.
Possible connections:

LAN connection

P2P connection
1 2
If you are working in configuration 1 (LAN connection), you must make sure that the PC is connected to the LAN according to the settings required by the Ethernet network
(check that the parameters, DHCP, DNS, IP address and the other settings of the network are configured correctly – the details must be obtained from the router manual
found in the installation documents or, in the case of systems installed in large tertiary facilities or companies, these must be requested directly to the IT Manager, in charge
of network management).
ATTENTION: a cross cable must be used in a P2P connection.
If, on the other hand, you are working according to configuration 2 (P2P connection), a network card setting is required, as shown in the example below:
11