AERMEC AER Connect Manual De Instrucciones página 50

4.3 FAN COILS / MZC PLENUM MENU
In the fan coils ( ) or MZC plenum (
will list them).
In the selected zone (see light blue area) you can make changes to the six operation settings, mode and enabling by using the keys described below.
1. Use the key to enable/disable the highlighted zone
2. Use the key to activate the pop-up window to set the following:
— Winter operation settings
— Summer operation settings
— Forcing the setpoint from supervision
— Forcing the operating mode
To activate the winter setpoint change (the procedure is similar for the summer one), you must press in the box that delimits it to open the edit window:
To change the heating setting, enter the desired value in the data change section and then confirm acceptance of the data using the key
Select the forcing of the setpoint from the supervisor by using the form shown in the figure below. By pressing the "padlock" icon, you can choose the mode (FORCED: closed
padlock, or NOT FORCED: open padlock):
Change the mode from the supervisor by actuating the hole shown in the figure below. When the pop-up opens, the page displays the actual operating mode of the zone
(OFF/AUTO/V1/V2/V3/AUX), then press the icon (
If the LOCAL Mode is selected, the selected zone is allowed to work in the mode set in the interface panel associated with it.
) menu you can view the list of all the zones present for every VMF system (if there are several VMF-E6 systems, the right column
) to choose how to operate the fan coil:
.
23