Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PARAMETERS TABLE
FUNCTION
F1 UNT
F2 EL
F3 PRT
TECH
P1 LIN
P2 CAL
P5 GRA
32
DESCRIPTION
•
Sets the which units want to use: g / ct / lb / oz / d / gn / ozt / dwt / mm / tl.T / tl.c / tl.t / t use
to switch, use
•
Set the backlight to be on, automatic or off.
•
EL on: Backlight always on
•
EL Au: Backlight automatically turn on
•
EL off: Backlight allways off
•
Use
to switch, use
•
P cont, continuous sending.
•
P auto, when the weight is stable sends the data.
•
P prt, printer. Press
4800 or 9600 bps), press
selects the printer (LP-50 or TP), press
•
Pin
•
Enter the programming and calibration menus by entering the correct password (
) and press
•
Linear calibration.
•
Press
. Display will show PIN again. Press keys
•
Display will show UNLOAD. Take off all the weight of the tray. Display will show the first request
of weight for the calibration. Place this weight on the tray, when the balance is stable ignites the
stability indicator and accepts this weight automatically.
•
After the first calibration of weight, display will show the following calibration weight. Place this
weight on the tray, when the balance is stable ignites the stability indicator and accepts this weight
automatically.
•
After the second calibration of weight, display will show the following calibration weight. Place this
weight on the tray, when the balance is stable ignites the stability indicator and accepts this weight
automatically.
•
The scale will begin to count backwards until reaching zero after it has accepted the last weight.
During the count down, you must retire all the weight of the platform.
•
The scale becames in normal weighing mode.
•
After entering in the calibration mode, display will show UNLOAD. Take off all the weight of the tray.
When the scale is stable, it will fix initial zero point automatically. Then display will show LOAD.
Place the weight for the calibration on the scale.
•
Minimum calibration weights:
• BAT300, 50g.
• BAT600, 100g.
• BAT1500, 300 g.
• BAT3000, 500 g.
•
Place this weight on the tray, when the balance is stable ignites the stability indicator and accepts
this weight automatically.
•
The scale will begin to count backwards until reaching zero after it has accepted the weight. During
the count down, you must retire all the weight of the platform.
•
The scale becames in normal weighing mode.
•
Gravity.
•
It appears the value of gravity, to change this value use the keys:
•
, places the value to 0.
•
, increases the value of the active digit.
•
, changes the active digit at right.
•
, changes the active digit at left.
•
Press
to save.
key to sure.
key to sure.
, now you can select the speed of transmission (600, 1200, 2400,
to change speed and
to change printer and
key to enter.
USER'S GUIDE
to save the wished speed. Now it
to save.
,
,
y
to enter.
EN
EN
Publicidad
Tabla de contenido
