How To Assemble Your Ceiling Fan - Fanimation AIRE DELUXE FP6245B Serie Manual Del Usuario

How to Assemble Your Ceiling Fan

1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger ball
for reinstallation in Step 6. (Figure 1)
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws in the downrod support
of the motor assembly. Route the black, white and
blue wires through the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Downrod
Set Screw
Hairpin Clip
Downrod
Set Screws (2)
Set Screws and
Locking Nuts (2)
Motor Coupling
Cover
7
Pin
Hanger Ball
Figure 1
Clevis Pin
Figure 2
Black, White and
Blue wires
Figure 3
Downrod
Hairpin Clip
Clevis Pin
Figure 4
Ceiling Canopy
Canopy Screw
Cover
Figure 5