Publicidad

Enlaces rápidos

Model #
716Wb
Entertainment Center
Assembly Instructions
Congratulations!
This fine piece of furniture will make a handsome
addition to your home. For the best results, start by
reading both the Assembly Instructions and
Finishing Hints before you begin your project.
For normal household use only.
recommended for commercial use.
Do not climb, sit or stand on this piece of
furniture.
Unload items from this unit prior to moving.
Do not overload shelves on this unit.
Before loading or moving this unit, check all screws
and supports for tightness.
For maximum stability, attach unit to the wall using
the enclosed hardware as per instructions.
P.O. Box 2827
Eugene, OR 97402 USA
Service Policy:
which are defective, missing or damaged
during assembly. Please contact Whittier
Wood Products customer service department
directly (by phone, fax, mail or email) for
replacement parts.
Hours:
Our friendly customer service staff
can be reached Monday-Friday 7:00 a.m. to
5:00 p.m. (Pacific Time). A message can be
left 24 hours a day, 7 days a week.
To Order:
Provide the complete furniture
model number (upper left corner of this
page), part letter, production code, quantity
needed, reason for replacement and your full
name and address along with a telephone
number in case we need to contact you.
Parts ship from our Eugene, Oregon factory
within 1 or 2 business days from the time
we receive the request. Please allow 5-10
business days for delivery.
Outside U.S. or Canada: 541-687-0213
Fax: 541-687-2060 • www.whittierwood.com
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Read both the Assembly Instructions and Finishing
Hints completely before beginning.
Store the parts: 1) in their box; 2) in a dry place; 3) in
temperatures ranging from 40° to 90°. (Not on a cold,
possibly damp, cement floor.)
Inspect your furniture periodically for any loose glue
joints or screws, or any other problem which may
be affecting the stability of your furniture. Tighten or
repair as needed.
Production Code:
We will replace any parts
Rev. 8/07

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Whittier Wood Products 716Wb

  • Página 1 Model # 716Wb Entertainment Center Assembly Instructions Service Policy: We will replace any parts which are defective, missing or damaged during assembly. Please contact Whittier Wood Products customer service department directly (by phone, fax, mail or email) for replacement parts.
  • Página 2 — Qty. 1 Db — Center Shelf — Qty. 1 Sb — Large Adjustable Shelf — Qty. 1 Eb — Bottom Shelf — Qty. 1 Tb — Small Adjustable Shelf — Qty. 2 PAGE 2 – 716Wb — Rev. 8/07...
  • Página 3 R — #8 x 5/8" Pan Head Screw — Qty. 8 Z — Tipping Restraint Kit — Qty. 1 O — Tack Glide — Qty. 2 U — Shelf Bracket — Qty. 12 Rev. 8/07 — 716Wb – PAGE 3...
  • Página 4: Tools Required

    Veneer parts – apply stain to unexposed portion of bottom shelf. See FIGURE 2. b) Alder pieces – apply stain to back of base. See FIGURE 3. FIG. 1 1. Lay out the wood parts in their approximate locations to aid in the identification and assembly. PAGE 4 – 716Wb — Rev. 8/07...
  • Página 5 • 6 in the Right Side Panel (Bb) • 9 in the Top Shelf (Cb) • 3 in the Center Shelf (Db) Note: Be sure these go into holes as shown in Fig. 3. Rev. 8/07 — 716Wb – PAGE 5...
  • Página 6 5. Attach the Upper Vertical Divider (Ib) to the Center Shelf (Db) with three #8 x 1 " Black Screws (X) through the predrilled holes in the center shelf and into the pilot holes in the bottom edge of the vertical divider. Start all 3 screws BEFORE fully tightening. PAGE 6 – 716Wb — Rev. 8/07...
  • Página 7 7. Attach the Left Side Panel (Ab) to the Center Shelf (Db) and the Bottom Shelf (Eb) by sliding the Rafi x Bolts (LL) into the Rafi x Cams (KK). Tighten the cams. See FIGURE 7. Repeat and attach the Right Side Panel (Bb) Rev. 8/07 — 716Wb – PAGE 7...
  • Página 8 9. Attach the Crown Moulding (FF) to the Top Shelf (Cb) and the Base (GG) to the Bottom Shelf (Eb) by sliding the Rafi x Bolts (LL) into the Rafi x Cams (KK). Tighten the cams. See FIGURE 9. PAGE 8 – 716Wb — Rev. 8/07...
  • Página 9 Lay the Corner Brace (Q) so that its bottom edge is on the line and screw the corner brace to the side panel and base with #8 x 5/8" Pan Head Screws (R). See FIGURE 10a. Screw Adjustable Glides (P) into corner braces. Rev. 8/07 — 716Wb – PAGE 9...
  • Página 10 13. Rotate Adjustable Glides (P) in the Corner Braces (Q) until unit stands level. TIPPING RESTRAINT: 14. When you have determined the location of your unit, install the Furniture Tipping Restraint (Z). Carefully follow the instructions contained on the package. PAGE 10 – 716Wb — Rev. 8/07...
  • Página 11: Centro De Para Tv Y Equipo De Audio Y Video

    Modelo # 716Wb Centro de Para TV y Normas para obtener servicio: Reemplaza- Equipo de Audio y Video remos las piezas que tengan defectos, falten o se dañen durante el armado. Sírvase comunicarse con Instrucciones para Armar el departamento de servicio al cliente de Whittier Wood Products directamente (por teléfono, fax,...
  • Página 12: 716Wb Centro Para Tv Y Equipo De Audio Y Video

    716Wb Centro para TV y equipo de audio y video Lista de piezas ANTES DE ENSAMBLAR, verifique que haya recibido todas las piezas que se listan en la lista de piezas que se presenta a continuación. Parte Descripción Cantidad Parte Descripción Cantidad Parte Descripción...
  • Página 13 Philtruss #6 x 5/8" (NN). Tenga cuidado de no apretar excesivamente los tornillos, porque podría desgastar la madera. Consulte la FIGURA 10. 716Wb SP — Page 3...
  • Página 14 No. de modèle 716Wb Centre Audiovisuel Politique de service : Nous remplacerons toutes Instructions de Montage les pièces défectueuses, manquantes ou endom- magées pendant le montage. Veuillez contacter directement le service clientèle de Whittier Wood Products (par téléphone, fax, courrier ou e-mail) pour obtenir les pièces de remplacement.
  • Página 15: Liste Des Pièces

    • Dix dans l'étagère inférieure (Eb) • Trois dans le séparateur vertical supérieure (Ib) 5. Montez le Séparateur Vertical Supérieure (Ib) • Trois dans le séparateur vertical inférieure (Jb) sur l'Étagère Centrale (Db) au moyen des vis Page 2 – 716Wb FR...
  • Página 16 à l'aide de la vis Philtruss #6 x 5/8po (NN). Prendre garde de ne pas trop serrer les vis pour éviter de déchirer le bois. Voir la FIGURE 10. 716Wb FR – Page 3...

Tabla de contenido