Replacing The Battery - Omron Gentle Temp 520 Manual Del Usuario

MC-520-E_A_M_main.book Page 13 Monday, April 16, 2018 5:03 PM
4. Troubleshooting and Maintenance
4.2
Maintenance
• Please check the device if damaged after it is dropped. If unsure, please contact the OMRON retail outlet or
distributor for having the device checked.
• The probe is the most delicate part of the unit. Use care when cleaning the Infrared sensor to avoid damage.
• If the unit is accidentally used without the probe cover, clean the probe as follows:
a.After measurement, use a cotton swab moistened with alcohol (70% concentration) to clean the probe and probe lens.
b.Allow at least 1 minute for the probe to fully dry.
• If the unit is dirty, use a cotton swab or cloth moistened with alcohol (70% concentration) to clean it.
• Do not store the unit in the following types of places. Doing so may damage the unit.
- Wet locations.
- Locations with high heat and humidity or those that are exposed to direct sunlight. Areas close to heating
equipment, dusty locations, or environments where there are high salt concentrations in the air.
- Locations where the unit will be subjected to leaning over, falling, shock or vibration.
- Pharmaceutical storage areas or locations where corrosive gases are present.
4.3

Replacing the Battery

Battery: CR2032 Lithium Button Battery
Use the battery within recommended period mentioned to it.
Note: To protect the environment, discard the used batteries in accordance with the local regulations regarding
waste disposal procedure. Disposal can be done at your retail store or at appropriate collection sites.
1.
Insert a pointed object into the battery cover pick hole.
Slide and remove the battery cover with your thumb.
EN
13