Environmental Protection - BGS technic 8766 Manual De Instrucciones

REMOVING
When you are sure that the hook is in the tire
valve, the valve can be pulled out by pulling hard
on the T-handle.
INSTALLING
Remove the dust cover from the new tire valve.
Screw the new tire valve onto the mounting shaft
(2). Apply plenty of tire fitting paste to the tire
valve.
Position the mounting cone (1) over the hole in
the rim for the tire valve.
Press the tire valve with the mounting shaft (2)
completely through the cone.
Then pull the mounting shaft (2) to pull the tire
valve into the valve seat of the rim.
Finally, dismantle the mounting shaft (2) from
the tire valve and remove the mounting cone (1).

ENVIRONMENTAL PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information. Dispose of this product at the end of its working life environmentally.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed