Uline H-305 Guia De Inicio Rapido

H-305
3M LABEL PROTECTION
TAPE DISPENSER
MODEL
Recommended Uline Tapes For Top Platform
Recommended Uline Tapes For Side Mandrel
Label Size
Laminating Platform Size (L x W)
Overall Dispenser Dimensions (L x W x H)
Weight
Dispenser is equipped with two keyhole slots in the
dispenser base and supplied with #10 x 3/4" self-
tapping screws and a strip of mounting tape.
TEMPORARY MOUNTING
Place mounting screws in the desired alignment with
keyhole slots. Tighten screws so the heads are 7/32"
above the surface. By mounting in this manner, the
dispenser can easily be removed and transported to
another area.
PERMANENT MOUNTING
The strip of mounting tape is divided into two sections
for easy application to the underside of the dispenser.
SIDE TAPE ROLL
Center the tape roll on drum so tape can be dispensed
forward, adhesive side down. (See Figure 2) Pull the
lead end of tape forward to the desired length and
bring the tape straight down onto the cut-off blade. Pull
down and slightly to one side to cut the tape.
LAMINATING TAPE ROLL
Place tape roll onto drum allowing 1/8 – 3/16" space
from the frame so the tape can be dispensed forward
adhesive side up. Pull 4-6" of tape from the roll around
the guide roller and under the rubber retainer. Pull tape
lead forward to cut-off blade. (See Figure 2)
PAGE 1 OF 6
1-800-295-5510
uline.com
SPECIFICATIONS
S-582, S-10201, S-15921, S-18720
INSTALLATION
See instructions on the tape liner and apply as directed.
Apply tape to a surface free of grease, oil and dust.
Figure 1
Front
Keyhole
Slot
LOADING
Laminating Roll
Cut-off Blade
Slide Roll
Cut-off Blade
Rubber
Retainer
Drum
Frame
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
H-305
S-6748, S-10214, S-18905
3⁄" Maximum Width
6 x 4⁄"
8⁄ x 6 x 6⁄"
3 lbs.
Weight Kit
Mounting Holes
1½" 4¾"
Keyhole
Slot
4⁄"
3/4"
Guide
Roller
Figure 2
1020 IH-305