Parts And Maintenance - Ingersoll Rand VT26 Serie Manual Del Usuario

RELEASED 19/Dec/2016 03:12:31 GMT
EN
Guard Adjustment
1. Disconnect the tool from the air supply.
2. Loosen hex screw near guard (C). Refer to Figure B on Page 2.
. To adjust guard, depress and hold guard button (D) or loosen guard screw depending upon
grinder model (Refer to Figure C on Page 2).
4. Position guard as needed and release guard button (D) or tighten guard screw depending
upon grinder model.
5. Tighten hex screw (C). Refer to Figure B on Page 2.

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN- 47586460001_ed1