Use & Maintenance; Functions; Use Of Manual Functions - Jacuzzi play SPHERE 90 Uso Y Mantenimiento

USE & MAINTENANCE

Functions

MANUAL FUNCTIONS
these functions are available for all models.
Showerhead (pos. E, see "Use of manual functions")
Vertical hydromassage (pos. C and D)
equipped with simultaneous water jets (4 upper and 4 lower nozzles),
which are emitted from the nozzles on the wall panel.
Jets can be tilted in four directions, by pressing the nozzle and mov-
ing it to the required position.
Large shower head (pos. A)
fastened to the centre of the hydraulic crosspiece, it creates an ample
rainfall jet.
Cascade dispenser (pos. B)
Built into the upper part of the multi-purpose panel, it creates a sail-
shaped jet.
ELECTRONIC FUNCTIONS
these functions are only available for TT models.
Steam bath
Scale removal cycle
Alarm
See chapter "Use of electronic functions".

Use of manual functions

GENERAL NOTES:
Never use water at a temperature of over 60 °C, to prevent dam-
age to the plumbing circuit.
N.B. It is also possible to use two functions at the same time. Just posi-
tion the diverter dial (G) half way between the two functions. If, for
example, you wish to use all the jets of the vertical hydromassage
at the same time, you must turn the dial to the position between
the symbols (C) and (D); naturally, there will be a drop in the water
flow rate of the single jets.
Remember to turn off the stop tap every time after use (R). If
temperatures above 38 °C have been selected, it is advisable to
turn back the thermostatic mixer dial to the position before the
safety lock.
Thermostatic tap fixture
E
D
R
Before using any function, it is advisable to adjust the water temper-
ature to the required value, in this way:
I Turn the dial (M) so that the notch matches up with the chosen
value. The knob is provided with a safety lock that fixes the tem-
perature at 38°C; to select higher temperatures, push the button
(P).
I If you wish to try the water temperature, turn the diverter dial
(G) to the "showerhead" (E) position and turn the stop tap (R) to
let water come out.
I Once the required water temperature has been reached, turn
the dial (G) to the position that indicates the chosen function.
10
A
B
C
G
38°
M
P