Preparations At The Workplace - Hilti SR 6-A22 Manual Del Usuario

Stroke length
Blade holder
4.1 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Sound power level (L
WA
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Vibration emission value for sawing chipboard (A
Uncertainty sawing chipboard (K)
Vibration emission value for sawing wooden beams (A
Uncertainty sawing wooden beams (K)
5

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Removing the battery
1. Press the two release buttons and hold them in the pressed position.
2. Pull the battery out of the product to the rear.
5.2 Removing the saw blade
1. Activate the transport lock or separate the battery from the power tool.
2. Push the locking lever up as far as it will go and hold it in this position.
3. Pull the blade forward out of the blade holder.
4. Allow the locking lever to return to its original position.
5.3 Replacing the contact shoe
1. Remove the battery. → page 17
2. Remove the saw blade. → page 17
3. Press the contact shoe lock button.
2186514
*2186514*
Printed: 23.01.2018 | Doc-Nr: PUB / 5391390 / 000 / 01
)
)
WA
)
pA
)
pA
2
3
4
)
h,B
)
h,WB
SR 6-A22
32 mm
0.5 in
SR 6-A22
97 dB(A)
5 dB(A)
86 dB(A)
5 dB(A)
SR 6-A22
17.5 m/s²
1.6 m/s²
21.3 m/s²
1.5 m/s²
English 17