Kobalt KRAD 1224B-03 Manual De Instrucciones página 10

OPERATING INSTRUCTIONS
The higher the torque setting, the more force the
right angle drill/driver produces to turn an object.
The proper setting depends on the job and the
type of bit, fastener, and material you will be
using. If the torque is too high, the screws may be
damaged or broken.
Select the drill mode for drilling and other heavy-duty
applications.
a. The torque indicator will blink to indicate that the
set torque is reached (only in 3-torques mode).
b. The LED indicator will turn off when the
direction-of-rotation selector is set to the
reverse direction, and will revert to the
previous setting when the selector is moved
back to the forward direction.
c. The LED indicator will turn off approximately 1 minute after the variable-speed trigger
switch is released.
WARNING
• Do not change the torque setting when the tool is operating.
6. LED Worklight
The LED worklight (C), located beneath the chuck,
will illuminate when the variable-speed trigger
switch (E) is depressed. This provides additional
light on the surface of the workpiece for operation
in lower-light conditions.
The LED worklight will turn off approximately 10
seconds after the variable-speed trigger switch is
released.
a. The LED worklight will blink rapidly if the
tool has stopped working in order to protect
internal circuits. Wait for the tool to cool down,
after which it can be started again.
b. The LED worklight will blink slowly to indicate
that the battery charge is very low.
7. Installing and Removing the Belt Clip with
Bit Holder
a. Align the rib of the belt clip with Bit holder (H)
with the hole on the base of the right angle
drill/driver.
b. Tighten the screw (I) securely with a Phillips
screwdriver (not included).
c. To remove the belt clip with bit holder, use
a Phillips screwdriver to loosen the screw
holding the belt clip with bit holder to the right
angle drill/driver.
5b
6
C
7
10
H
I