Broan ALLURE TM QS1 Series Manual página 3

PREPARE THE HOOD
®
ALLURE
TM
QS1 SERIES
RANGE HOOD
Page 3
PREPARE THE HOOD
El
El
Remove
Damper/Duct
Connector from
inside the hood.
Set connec-
tor aside - with
mounting screws
and parts bag.
DAMPER/DUCT
CONNECTOR
Remove Wit=
_Cover from
inside the hood.
Set cover and
mounting screw
aside.
53
AIR CHUTE
Remove Air
Chute - h_]d in
place with one
(1) screw.
NOTE: Be care-
ful not to discon-
nect any wires.
El Remove Baffle
from air chute.
El
WIRING
COVER
Remove either
top or back wir-
ing knockout and
install approved
Electrical Cable
Clamp_.
BAFFLE
BAFFLE
\
ELECTRICAL CABLE CLAMP
Non-Ducted Installation - Skip to "Connect
Wiring'section.
(3) #8 SCREWS
The following
Steps (6 thru
13) are for
DUCTED
INSTALLATION
ONLY.
E]
LIGHT
PANEL
Rotate baffle. Re-
insert baffle into air
chute (as shown) so
that baffle tabs fit all
the way into slots in
air chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted slots
on top of hood.
SLOTS
TABS
El Remove Panel held in with #8
_ht place
(3)
screws
and (2) #8 screws. Disconnect light assembly wire harness
(white connector).
El
Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between support fin and light panel.
SUPPORT FIN