Steam Ironing; Dry Ironing - Russell Hobbs 18653-56 Instrucciones

18 Move the r switch to 1.
19 The switch will glow.
20 When the boiler is ready to generate steam (2-3 minutes), the ~ light will glow.
21 It will then cycle on and off as the thermostat operates to maintain the temperature.
22 Turn the temperature control to bring the setting you want next to the thermostat light.
23 The thermostat light will glow.
24 When the iron reaches the set temperature, the thermostat light will go off.
25 It will then cycle on and off as the thermostat operates to maintain the temperature.
h STEAM IRONING
, If you intend to use steam, the temperature setting must be S or higher.
26 Set the steam control to the setting you want (S = low, # = high).
27 Press the steam button to produce steam, release it to stop the steam.
28 For a constant stream of steam, press the steam button, then slide the latch (on the rear of
the button) back, towards the rear of the iron, to lock the button down.
29 Slide the latch forward, to unlock it, and revert to normal use.
C PUMP NOISE
30 As you use up the steam, the pump will operate to pump more water into the boiler.
31 It'll be quite noisy at first, then quieten down, and stop.
32 You may carry on ironing – the pump is big enough to keep up.
n DRY IRONING
33 You can dry iron by just not pressing the steam button, but if you want to make sure you
don't press it accidentally, then you should iron with an empty reservoir.
34 Do your dry ironing first, then switch off, fill the reservoir, and do your steam ironing.
l VERTICAL STEAMING
35 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
36 Check that there is adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
37 Check that there is nothing behind the fabric that may be damaged by the steam.
38 Check that pockets, turn-ups, and cuffs are empty.
39 Set the temperature control to max.
40 Lift the iron off the fabric.
41 Press the steam button to produce steam, release it to stop the steam.
q LOW WATER
42 When the water level gets low, the q light will go out.
43 Switch off, unplug, and fill.
C AFTER USE
44 Sit the iron on the base unit.
45 Set the temperature control to •.
46 Move the p switch to 0.
47 Move the r switch to 0.
48 Unplug the appliance.
C CLEANING
49 Unplug the appliance and let it cool down before cleaning or storing away.
50 Clean the outside surfaces of the appliance with a damp cloth.
51 Remove spots from the soleplate with a little vinegar.
4