Snapper 2690826 Guía De Instalación Rápida

1
WARNING
The Operating Manuals (engine and equipment) and decals on the equipment contain safety
information to make you aware of the hazards and risks associated with mowers and how to
avoid them. This product and its approved attachments/accessories are designed and intended
only for lawn work or snow removal and are not intended for any other purpose. It is important
that you read and understand these instructions thoroughly before attempting to start or operate
this equipment.
2
Check Tire Pressure
Tires are over-infl ated for shipping purposes. The tires must be set at
the correct pressures for optimum traction and best cut.
Note: These pressures may diff er slightly from the "Maximum Infl ation"
stamped on the side walls of the tires.
See illustration.
3
Check Oil Level
Engine is shipped with oil, however, oil should be checked
prior to use. See illustration below. Park tractor on a level surface.
Note: See Operator's Manual if oil is needed.
3
1
2
Mfg. No. 2690826
Read the Manuals
10 psi
(,68 bar)
5
7a
6
4
7b
4
+
WARNING
• Wear eye protection while handling the battery.
• To avoid an explosion, keep fl ames and sparks away from battery, especially while charging.
• Battery acid causes severe burns. Avoid contact with skin
Battery posts, terminals, and related accessories contain lead and lead compounds -
chemicals known to the State of California to cause cancer and reproductive harm. Wash
hands after handling.
+
12-14 psi
(,82-0,96 bar)
Copyright © 2010 Briggs & Stratton Corporation Milwaukee, WI, USA. All rights reserved.
Charge Battery
BATTERY SAFETY RULES
CHARGING THE BATTERY
1. Remove the ignition key.
2. Always attach the POSITIVE (+) charger clamp to the (+) terminal of the
battery fi rst.
3. Attach the NEGATIVE (‫ )ـ‬charger clamp to the (‫ )ـ‬terminal of the
battery last.
4. Charge battery according to the instructions provided by the charger
manufacturer. Do not charge at a rate higher than 10 amps.
5. When charging is complete, connect the NEGATIVE (‫ )ـ‬battery cables.
6. Coat the cable ends and the battery terminals with Briggs & Stratton
Battery Terminal Protector (Part Number 100068) or equivalent.
10 AMPS
+
( )
( )
( ) (2x)
Form No.: 1737161
(Rev. E)