geberit AquaClean Sela Instrucciones De Montaje página 24

EN
Tests after installation
Switching on the Geberit
AquaClean Sela
Prerequisites
Geberit AquaClean Sela is installed and connected.
1
Open the water supply at the ball valve.
2
If there is no direct mains connection,
connect the mains plug.
24
3
Using a screwdriver, open the cover on the
right-hand side.
1
2
4
Switch on the power switch.
Result
The LED on the control panel flashes blue three
times. After this, the LED is lit for 10 min after the
last user detection.
B1070-005 © 08-2015
966.102.00.0 (04)