AL-KO GT 36 LI Manual De Instrucciones página 20

en
HELP IN CASE OF MALFUNCTIONS
Malfunction
Motor does not run
Motor does not stop
Trimmer vibrates
Battery operating time is
significantly shorter
Battery cannot be charged Charge plug or contact socket con-
Additional cutting line is
not supplied
ADVICE
If you encounter any malfunctions that are not listed in this table or which you cannot rectify
yourself, please contact our responsible customer service.
GUARANTEE
We will resolve any material or manufacturing faults on the machine during the legal warranty period
for claims relating to faults, in accordance with our choice either to repair or replace. The legal warranty
period is determined by the legislation of the country in which the machine was purchased.
Our warranty promise applies only if:
these operating instructions are complied with
the machine is handled correctly
original spare parts have been used
The guarantee excludes:
Paint damage that can be attributed to normal wear and tear
Wear parts that are marked with [xxx xxx (x)] frame on the spare parts card
Internal combustion engines (these are covered by the guarantee provisions of the corresponding
engine manufacturers)
The guarantee period commences with purchase by the first end user. The date on the proof of purchase
is decisive. In the event of a guarantee claim, please take this guarantee declaration and the original proof
of purchase, and contact your dealer or the nearest authorised customer service centre. This statement
does not affect the purchaser's statutory claims for defects against the vendor.
20
Possible cause
Flat battery
Battery is not engaged or has
come loose
Battery is too cold or too hot
Machine defective
Switch in top handle is defective
Spool is contaminated
Grass too long or too wet
Cutting height too low
Battery flat because not used for
some time
Battery service life expired
taminated
Battery or charger defective
Spool is empty
Solution
Charge the battery
Check the location of the battery
and engage it if necessary
Lightly warm up the battery or al-
low it to cool down
Send in the machine
Clean the spool, renew it if ne-
cessary
Let it dry, set a higher cut
Raise the cutting height
Charge the battery
Renew the battery. Only use ge-
nuine accessories from the manu-
facturer
Order spare parts acc. to the spare
parts card
Changing the spool
The warranty becomes void if:
unauthorised repair attempts
unauthorised technical modifications
non-intended use
Help in case of malfunctions
36 Li