Putting Into Service - HellermannTyton E4500 Instrucciones De Uso

UK
IMPORTANT:
Read this notice carefully to get used to your appli-
ance before connecting the gas cartridge. Please keep
these instructions in a safe place for future reference.
FITTING THE CARTRIDGE:
This hot-air heating gun must be used only with gas
cartridges of the type P445 (60 g/110 ml). It can be
dangerous to use any other gas cartridge. Guilbert
Express and HellermannTyton decline all liability if
another make of cartridge is used. The gas cartridge
must only be changed out doors and far away from
other people.
Check that the valve is closed. Stand the hot-air hea-
ting gun in vertical position, screw the cartridge home
by hand only. See fig. 1

PUTTING INTO SERVICE:

• Set to medium flow by turning the control valve
(position 1): see fig. 4
• Press the piezo button immediately after opening
the gas valve, several times if necessary: see fig. 5
• Adjust heating by turning the valve: see fig. 6
• To fit nozzles: see fig. 2
• To fit protection spring: see fig. 1
• Temperature depends on distance:
Without nozzle, see fig. 7
With flat nozzle, see fig. 8
• With the reflector nozzle, soft soldering copper
pipe up to Ø 32 mm
• Adjustable from 400 °C up to 750 °C
• Max. gas consumption: 75 g/h
• Appliance under direct butane pressure
• The heating gun can be used in temperatures
above -8 °C.
• 'Flaring': If a yellow flame is produced from the
nozzle (instead of hot air) it is known as 'flaring'.
This may occur during a short period, for a few
seconds, if the tool has been held upside down
before igniting.
In order to avoid flaring, ignite the E4500 gun in
an upright position and wait for 5 seconds before
using in any position.
I n s t r u c t i o n s f o r u s e
H o t - a i r h e a t i n g g u n E 4 5 0 0
MALFUNCTIONS:
• The cartridge is empty: close valve and change gas
cartridge
• Gas nozzle and filter are blocked: change the gas
nozzle
• In cases of prolonged malfunctioning, the hot-air
heating gun must be sent back to retailer or
manufacturer.
SAFETY:
• Attention! Parts (such as burner head) may become
very hot
• Keep away from children
• Before connecting the gas cartridge, check the
safety elements such as the O-rings between the
head and the gas cartridge carefully
• Do not use an appliance with damaged O-rings
• Do not use an appliance if it's leaking, damaged or
not working properly
• In the event of leakage (smell of gas), immediately
put the hot-air heating gun outside in a well ventil
ted place, well away from any source of ignition so
that the leak can be located and stopped
• If you want to check your hot-air heating gun for
leaks, do it outside
• Do not look for leaks with a naked flame; use
soapy water solution
• The appliance must not be used in a room where
there are flammable or toxic materials stored
• Do not use the flame at less than 40 cm from the
nearest wall or ceiling
• Before storing the heating gun, make sure that it
has cooled down, then unscrew the cartridge
• Gas cartridge must be changed in very well venti-
lated rooms (without any source of ignition),
preferably outside and well away from other people
and flammable materials
• Store the hot-air heating gun in a cool, dry and
well ventilated place
• The gas cartridge is a pressurised container, do not
pierce or place in direct heat or sunlight, do not
expose to temperatures exceeding 50 °C.
www.HellermannTyton.co.uk