Height Adjustment - Black and Decker NST1118 Manual De Instrucciones

• Once the guard is installed,
remove the covering from the line
cut-off blade, located on the edge of
the guard
attachinG the auxiliarY
hanDle (nSt1118)
The handle (3) is shipped with the screw
partially threaded in to prevent loss.
To attach the handle:
1. Remove the screw.
2. Slide the handle onto the handle
housing as shown in figure 6.
3. Thread the screw back into the
hole and tighten securely with a
screwdriver.
attachinG the auxiliarY
hanDle (nSt2118)
• To attach the handle, press in on
the buttons (f) on both sides of the
upper housing as shown in figure 7.
• Position the handle as shown in
figure 8 (with the Black & Decker
logo facing upward). Partially push
the handle on so that it will hold
the buttons in when you release
them with your hand.
6
3
7
f
8
• Push the handle completely
onto the housing and position
it slightly until it "snaps" into
place (figure 9).
• To adjust the handle up or
down, press in on the button
(g) and raise or lower the
handle.
• The handle should be
adjusted so that your front
arm is straight when the
trimmer is in the working
position.

heiGht aDJuStment

caution:
Adjust the
length of the trimmer to obtain
proper working positions as
shown in figure 11.
• The overall height of the
trimmer can be adjusted by
loosening the collar (4) and
rotating it in the direction of
the arrow shown in figure 10.
• Move the upper housing
straight up or down. When
the desired height is
achieved, tighten the collar
by rotating it opposite of the
direction shown in figure 10.
7
9
10
4
g