Sears Kenmore 796.8138 Manual De Uso Y Cuidado página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

VENTING
THE DRYER (continued)
Routing and Connecting
Ductwork
Follow the guidelines
below to maximize
dryer
performance
and reduce lint buildup and condensation
in the ductwork.
NOTE: Transition duct (from dryer to wall) and fittings
are NOT included
and must be purchased
separately.
• Use 4 inch (102mm) diameter
rigid or semi-rigid
metal duct.
• The exhaust duct run should be as short as possible.
• Use as few elbow joints as possible.
• The male end of each section of exhaust duct must
point away from the dryer. See figure on lower right of
page.
• Use duct tape on all joints. Never use screws.
• Insulate ducts that run through
unheated
areas in order
to reduce condensation
and lint buildup on
duct surfaces.
• The total length of semi-rigid
metal transition
duct
should not exceed 8 ft. (2.4 m).
A WARNING:
Failure to follow these
guidelines will result in poor performance,
product
failure, and/or
result in fire or death.
IMPORTANT:
Failure to exhaust the dryer, per the
guidelines
included
within these instructions, may
result in unsatisfactory
dryer performance.
All venting
and ductwork
beyond the exterior
of the dryer is the
responsibility
of the consumer. Product failure, as a
result of improper
venting, is not covered by the dryer
wa rra
nty.
Connecting
the Dryer Vent
O
Verify all ducts and elbows are clean and free
from any blockages.
Measure duct length. DO NOT exceed the
maximum
length listed in the Duct Length Chart.
Connect dryer exhaust to existing duct.
• Only use duct tape or clamps.
• DO NOT use screws to secure ductwork.
• Use rigid or semi-rigid
metal ducts.
• DO NOT use plastic or thin metal foil tubing
for ductwork.
• The male end of each elbow must always point in
the direction of the airflow.
Correct
Venting
E
Incorrect Venting
!
Male
Ends
mAI
1
O
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 796.9138

Tabla de contenido