Time And Status Display - Sears Kenmore 796.8138 Manual De Uso Y Cuidado

TIME AND STATUS DISPLAY
The Time and Status Display shows the cycle time, cycle progress, and vent status. When the dryer is turned on, the
display will illuminate.
Q
O TIME DISPLAY O
When a cycle is selected, the display will indicate
the default time for that cycle including selected
options or adjustments. In AUTO DRY cycles, the
time remaining will be estimated and may change
during the cycle, depending on the condition of the
load. In TIMED DRY, the time displayed will be the
actual time remaining.
O
O
CHECK FILTER LIGHT
The CHECK FILTER light will blink before each load,
as a reminder to check the lint filter. Always clean
the lint filter before every cycle.
CYCLE STATUS INDICATORS
This portion of the display shows which stage of the
drying cycle is currently under way (DRY, COOLING,
or WRINKLE GUARD).
O
CHECK VENT INDICATOR
(DUCT BLOCKAGE SENSING SYSTEM)
The CHECK VENT duct blockage sensing system
detects and alerts you to blockages in the ductwork
that reduce exhaust flow from the dryer. This light
does not indicate any problems with your dryer. If
this light blinks, it indicates that your home's exhaust
system has a serious restriction, which is not covered
by your dryer's warranty. Call 1-800-4-MY-HOME ®
for information regarding duct cleaning services
ofl:ered through Sears.
ADD WATER INDICATOR
If the steam feeder runs low on water, the ADD
WATER light will blink and the cycle will cancel.
Refill the steam feeder and then restart the cycle.
23