HP DesignJet T900 Serie Información De Introducción página 6

Message or code
[Color] cartridge is non-HP ink
[Color] cartridge is out of ink
[Color] cartridge is very low on ink
Printhead error: not present
Printhead error: replace
Printhead error: reseat
Printhead out of warranty
Printhead replacement incomplete.
Restart it.
Replace [color] cartridge
Replace incorrect [color] cartridge
Reseat [color] cartridge
05.5:10
08:04
08:08
39.1:01
39.2:01
61:01
61:04.1, 61:04.2
61:08
61:08.1
61:08.2
61:09
63:10
4
Introductory Information
Recommendation
You are recommended to install an HP original ink system for optimum system
performance.
Replace the cartridge.
Ensure that you have a new cartridge of the same color ready.
Insert a printhead.
Remove the non-functional printhead and insert a new printhead.
Remove and reinsert the same printhead, or try cleaning the electrical
connections. If necessary, insert a new printhead.
The printhead's warranty has ended, because of the length of time it has been
in operation, because of the volume of ink used, or because non-HP ink has
been used in the system. See the limited warranty document.
Restart the printhead replacement process.
Replace the cartridge.
Replace the cartridge and check the supported ink cartridges.
Remove and reinsert the same cartridge.
Retry the operation that you were attempting. If it fails again, restart the
Roll 1 has been unexpectedly unloaded. Reload the roll.
Roll 2 has been unexpectedly unloaded. Reload the roll.
Disconnect the power cord.
Reconnect the power cord and turn on the printer.
Send the same job to the printer again.
Resend the job.
The job cannot be printed because it is password-protected.
The job cannot be printed because it contains errors. Resend the job from the
Embedded Web Server.
Resend the job.
Disconnect the power cord.
Reconnect the power cord and turn on the printer.
Check that the network cable is correctly connected.