HP DesignJet T900 Serie Información De Introducción página 7

Message or code
63:20
71.03, 71.08
74.01
74.1:04
74.8:04
75.11:10
75.21:10
76:03
78:08
79:03, 79:04
81:01
86:01
94, 94.1
Power
Frequency
AC voltage
Maximum current
Recommendation
A potential problem has been detected in the network interface.
Disconnect the power cord.
Reconnect the power cord and turn on the printer.
Send the same job to the printer again.
Out of memory. To avoid this, in the HP-GL/2 driver select the
and then Send job as a
Disconnect the power cord.
Reconnect the power cord and turn on the printer.
update is in progress.
download it again.
Preventive maintenance 1 is recommended.
Preventive maintenance 2 is recommended.
The printer's hard disk is full. You may want to use Disk Wipe to free some
space.
supports borderless printing.
Open the printer window and make sure that there are no obstacles restricting
the movement of the drive roller. If the paper has jammed, clear the obstruction
by following the instructions in the front panel.
Open the printer window and make sure that there are no obstacles restricting
the movement of the printhead's carriage. If the paper has jammed, clear the
obstruction by following the instructions in the front panel.
Restart color calibration.
120W
50/60Hz
~100-240V
2A
bitmap.
Advanced tab
5
Introductory Information