Würth RL 3 Instrucciones Para El Manejo página 14

RL 3.book Seite 14 Mittwoch, 19. November 2008 9:14 09
Product Specifications
Rotation laser
Article number
Working range 1)
Levelling accuracy 1) 2)
Self-levelling range, typically
Levelling time, typically
Rotational speed
Operating temperature
Storage temperature
Laser type
Laser class
Laser beam diameter at the
1)
unit
Tripod connection (horizontal
and vertical)
Batteries
Operating duration (alkaline) approx. 50 h
Weight
Protection type
1) 2)
at 21 °C, along the axis
Intended Use
The unit is intended for projecting and checking pre-
cise horizontal planes, vertical lines, alignment lines
and plumb points.
The user is responsible for damage caused by usage
other then intended.
Protection of the Unit
J Avoid heavy shocks or falls. After heavy exterior
influences on the unit, always perform a precision
check before continuing work (see Section Level-
ling Accuracy).
J Do not immerse the unit in water.
J Do not expose the unit to extreme temperatures
and temperature variations (e. g., do not leave in
vehicles).
J If the unit is not used for a long period, the batter-
ies must be removed (danger of self-discharge
and corrosion).
14
Open the battery lid 14.
RL 3
Insert two batteries into the battery compartment and
0714 640 803
close the battery lid 14 again.
to approx100 m
Note: To prevent the batteries from running out
<±1 mm/10 m
while storing, remove the batteries from the battery
±5°
compartment.
30 s
-1
50/200/600 min
–5 ... +45 °C
Place the unit in the horizontal or vertical position on
–20 ... +70 °C
a stable base, on a tripod or mount in a wall holder
635 nm, <5 mW
(accessory; see figure).
3R
approx. 5 mm
5/8"
2 x 1.5 V (LR20)
Switching On/Off
ca. 1.5 kg
IP 54 (dust and
splash water pro-
tected)
For switching on, press the On/Off button 6. The in-
dicators 5, 3 and 10 light up for 2 seconds. The
tool immediately starts the automatic levelling (see
Automatic Levelling). The tool is levelled when the la-
ser beam lights up and the levelling indicator 3 lights
up continuously. The laser starts in the last run ope-
rating mode. The levelling indicator 3 lights up con-
tinuously for 5 minutes, and then flashes 1 time eve-
ry 4 seconds.
The operating mode can already be specified during
levelling with the operating mode buttons or with the
direction buttons (see Using the Operating Modes).
For this, use the remote control so that the tool does
not interrupt the levelling.
To switch off, press the On/Off button 6.
Using the Operating Modes
Inserting Batteries
Putting into Operation
Horizontal Position
Vertical Position
Do not look into the laser beam.
Do not point the laser beam at persons or
animals.
Operating Modes
Point operation
Rotational operation generally requires
the use of a receiver (accessory). You can
choose from three rotational speeds.