Vibration Information - Worx WX252 Manual Original

VIBRATION INFORMATION

Vibration total values (triax vector sum) determined according to EN 62841:
Vibration emission value a
Uncertainty K = 1.5m/s²
The declared vibration total value and the declared noise emission value have
been measured in accordance with a standard test method and may be used for
comparing one tool with another.
The declared vibration total value and the declared noise emission value may also
be used in a preliminary assessment of exposure.
WARNING: The vibration and noise emissions during actual use of the
power tool can differ from the declared value depending on the ways in
which the tool is used especially what kind of workpiece is processed dependant on
the following examples and other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is sharp and in good
condition.
The tightness of the grip on the handles and if any anti vibration and noise
accessories are used.
And the tool is being used as intended by its design and these instructions.
EN This tool may cause hand-arm vibration syndrome if its use is not
adequately managed.
12
WARNING: To be accurate, an estimation of exposure level in the actual
conditions of use should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when it is running idle but not
actually doing the job. This may significantly reduce the exposure level over the
total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and keep well lubricated
(where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise accessories.
Plan your work schedule to spread any high vibration tool use across a number of
days.
ACCESSORIES
5hr charger
25mm screwdriver bits (PH0 PH1 PH2
PZ1 PZ2 SL4 HEX4 HEX5 T10 T20
We recommend that you purchase your accessories from the same store that sold
you the tool.Refer to the accessory packaging for further details. Store personnel
can assist you and offer advice.
= 1.113m/s²
h
WX252/WX252.1
1pc
10pcs