Statement 1045-Short-Circuit Protection; Statement 1046-Installing Or Replacing The Unit; Statement 1047-Overheating Prevention; Statement 1048-Rack Stabilization - Cisco Catalyst 9500 Serie Manual Del Usuario

Statement 1045—Short-Circuit Protection
Warning This product requires short-circuit (overcurrent) protection to be provided as part of the building installation. Install
only in accordance with national and local wiring regulations.
Statement 1046—Installing or Replacing the Unit
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1047—Overheating Prevention
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
Warning
ambient temperature of : 50C
Statement 1048—Rack Stabilization
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before
Warning
you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over.
Statement 1051—Laser Radiation
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or view
directly with optical instruments.
Statement 1053—Class 1M Laser Radiation
Class 1M laser radiation when open. Do not view directly with optical instruments.
Warning
Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches
8
Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches