Statement 1074-Comply With Local And National Electrical Codes; Statement 2007-Emc Environmental Conditions For Products Installed In The European Union, Page - Cisco Catalyst 9500 Serie Manual Del Usuario

Statement 1074—Comply with Local and National Electrical
Codes
Installation of the equipment must comply with local and national electrical codes.
Warning
Statement 2007—EMC Environmental Conditions for Products
Installed in the European Union
This section applies to products to be installed in the European Economic Union.
The equipment is intended to operate under the following environmental conditions with respect to EMC:
• A separate, defined location that is under users control.
• As a minimum, earthing and bonding shall meet the requirements of ETS 300 253:1995 or CCITT
• AC power distribution inside the building shall be, as a minimum, one of the following types (as defined
In addition, if equipment is operated in a domestic environment, radio-frequency interference may occur.
Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches
10
K27:1996.
in IEC 60364-3:1993):
– TN-S
– TN-C
– TT
– IT
Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches