Statement 371-Power Cable And Ac Adapter; Statement 1004-Installation Instructions; Statement 1005-Circuit Breaker; Statement 1006-Chassis Warning For Rack-Mounting And Servicing - Cisco Catalyst 9500 Serie Manual Del Usuario

Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches
Statement 371—Power Cable and AC Adapter
Warning When installing the product, please use the provided or designated connection cables/power cables/AC
adaptors/batteries. Using any other cables/adaptors could cause a malfunction or a fire. Electrical Appliance and
Material Safety Law prohibits the use of UL-certified cables (that have the "UL" or "CSA" shown on the cord), not
regulated with the subject law by showing "PSE" on the cord, for any other electrical devices than products
designated by CISCO.
Statement 1004—Installation Instructions
Read the installation instructions before using, installing or connecting the system to the power source.
Warning
Statement 1005—Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective
Warning
device is rated not greater than:
20A
Statement 1006—Chassis Warning for Rack-Mounting and
Servicing
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure
that the system remains stable. The following guidelines are provided to ensure your safety:
•
•
•
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit
in the rack.
Regulatory Compliance and Safety Information—Cisco Catalyst 9500 Series Switches
5