Statement 1071-Warning Definition; Statement 7001-Esd Mitigation; Statement 7002-Intra-Building Lightning Surge (For Shielded Cables); Statement 7003-Telcordia Gr-1089 Nebs Standard For Electromagnetic Compatibility And Safety - Cisco Catalyst 9600 Serie Manual Del Usuario

Statement 1071 Warning Definition
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before
you work on any equipment, be aware of the hazards involved with electrical circuitry and be
familiar with standard practices for preventing accidents. Use the statement number provided
at the end of each warning to locate its translation in the translated safety warnings that
accompanied this device.
SAVE THESE INSTRUCTIONS
Statement 7001 ESD Mitigation
This equipment may be ESD sensitive. Always use an ESD ankle or wrist strap before handling equipment.
Connect the equipment end of the ESD strap to an unfinished surface of the equipment chassis or to the ESD
jack on the equipment if provided.
Statement 7002 Intra-Building Lightning Surge (For
Shielded Cables)
Shielded (screened) cables utilized for connection to intra-building telecommunication ports shall be grounded
at both ends of the cable.
Statement 7003 Telcordia GR-1089 NEBS Standard
for Electromagnetic Compatibility and Safety
Warning
The intrabuilding port(s) of the equipment or subassembly must use shielded intrabuilding
cabling/wiring that is grounded at both ends.
Statement 7004 Special Accessories
To comply with emission and immunity requirements, shielded cable is required for connection to Ethernet
Ports.
Regulatory Compliance and Safety Information Cisco Catalyst 9600 Series Switches
8
Regulatory Compliance and Safety Information Cisco Catalyst 9600 Series Switches