Statement 7005-Intrabuilding Lightning Surge And Ac Power Fault; Statement 7012-Equipment Interfacing With Ac Power Ports; Statement 7013-Equipment Bonding Networks Cbn; Statement 7016-Battery Return Conductor - Cisco Catalyst 9600 Serie Manual Del Usuario

Regulatory Compliance and Safety Information Cisco Catalyst 9600 Series Switches
Statement 7005 Intrabuilding Lightning Surge and
AC Power Fault
Warning The intrabuilding port(s) of the equipment or subassembly must not be metallically connected
to interfaces that connect to the OSP or its wiring. These interfaces are designed for use as
intrabuilding interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require
isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient
protection in order to connect these interfaces metallically to OSP wiring.
Statement 7012 Equipment Interfacing with AC
Power Ports
This equipment shall be connected to AC mains provided with a surge protective device (SPD) at the service
equipment complying with NFPA 70, the National Electrical Code (NEC).
Statement 7013 Equipment Bonding Networks CBN
Note This equipment is suitable for installations utilizing the insert Common Bonding Network (CBN).
Statement 7016 Battery Return Conductor
The battery return conductor of this equipment shall be treated as DC Isolated (DC-I).
Statement 7017 Minimum Steady State DC Input
Voltage
This equipment will operate without degradation at a minimum steady state voltage of -40V. The nominal
DC input voltage rating is -48V.
Regulatory Compliance and Safety Information Cisco Catalyst 9600 Series Switches
9