Seca 242 Manual De Instrucciones Y Garantía página 17

Assembly
seca 242
– Select a location for attaching the
measuring rod where the floor is level
and unyielding.
In order to avoid damage to the measuring rod during use, the heel plate must be
supported against the wall. The number of spacers used determines the dis-
tance of the measuring rod from the wall. You need to use at least one spacer
for each of the two mounting points.
– Place the spacers on top of one anoth-
er and screw them to the heel plate us-
ing the plastic nuts and bolts.
Alternatively
– Mark drill holes for the heel plate.
– Drill using a 5 mm drill bit.
– Push the rawlplugs supplied into the
holes.
– Mount the heel plate and the spacers
using two screws.
– Remove the cable tie (provided for
transport purposes) on the top measur-
ing rod.
– Push the top measuring rod onto the
plastic guide of the bottom measuring
rod and screw it tight using the pan-
head tapping screw.
– Place the bottom measuring rod on the
heel plate and hold the measuring rod
up to the desired point of attachment.
Use a spirit level to align it in the per-
pendicular.
– Mark the drill hole for the measuring
rod.
– Drill using a 5 mm drill bit.
– Push the rawlplug into the hole.
– Push the bottom measuring rod onto
the heel plate.
– Put the spacers between the measur-
ing rod and the wall and fix the measur-
ing rod in position.
Model 242/245
2.
3.
1.
GB 17