Spare Parts And Accessories - Flex XFE 7-15 125 Instrucciones De Funcionamiento Originales

Replacement of wear parts
Change Velcro pad
Pull out the mains plug.

Remove the polishing tool.

Place machine on its back.

Release and remove screws with Torx

wrench (1.).
Remove worn Velcro pad (2.).

Remove contaminants from interior.

Align securing holes and fit new Velcro

pad (3.).
20
XFE 7-15 125 / XFE 7-15 150 / XCE 10-8 125
Insert screws and tighten with Torx

wrench (4.). (Tightening torque 2.5-3.0 Nm
(1.8-2.2 ft. lb.))
Carry out test run. Check for imbalances

and vibrations.
CAUTION!
An incorrect torque setting can damage the
tool and the surfaces being worked on.
Repairs
Repairs may be carried out by an authorised
customer service centre only.

Spare parts and accessories

NOTE
Only the tools released by FLEX may
be used.
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com