Usage; Travel Lock - Beurer SatinSkin HL 36 Instrucciones De Uso

5. USAGE

The device should only be charged with a mains adapter with an output of min. 1 A.
1. Fully charge the device for approx. 90 minutes before the first use. You can either charge the device
directly (Figure ) or connect it to the charging and storage station
A
ing and storage station
delivery scope) or via a device with a suitable interface.
2. The battery level indicator
level indicator stays on continuously. The device is now ready for use. One charge is sufficient for
3
approx. 60 minutes of operation.
3. Press the ON/OFF button
4. To increase the speed setting, press the ON/OFF button
5. Guide the device slowly, steadily and without pressure over the skin with the illuminated side against
the direction of hair growth (Figure
in various directions over the skin to achieve the best result. The device can be used on dry skin or
in the shower or in the bathtub.
6. To switch off the device, press the ON/OFF button
red during battery operation, the battery is almost empty.
7. Using the trimming attachments
Small trimming attachment
Large trimming attachment
To do this, place the desired trimming attachment
8. Glide attachment
short hair. To do this, place the glide attachment for better skin contact
ment (Figure
5 F
9. Exfoliation attachment
the shaver attachment

Travel lock

The device has a travel lock. If the travel lock is activated, it is not possible to switch on the device.
The travel lock prevents the device from being switched on by accident (e.g. when being carried in a
suitcase).
1. To activate the travel lock, press and hold the ON/OFF button
cator will flash. The device is now locked. If you press the ON/OFF button
3
is activated, the battery level indicator
2. To deactivate the travel lock, press and hold the ON/OFF button
level indicator flashes. The device is now unlocked.
3
or the device to a suitable mains adapter (mains adapter not included in
4
flashes during charging. Once the battery is fully charged, the battery
3
to switch on the device.
2
). As hair doesn't always grow in one direction, guide the device
C
/
8 9
: 4 mm
8
: 8 mm
9
: For a pleasant feeling on the skin while shaving. Especially suitable for very
7
).
: Gently removes dry, dead skin cells and prevents ingrowing hairs. Remove
6
by gently pulling it out. Attach the exfoliation attachment
5
2
again. If the battery level indicator
2
you can cut your hair to two different lengths:
/ onto the shaver attachment
8 9
flashes briefly.
3
15
(Figure ). Connect the charg-
4 B
again.
on the shaver attach-
7
for 3 seconds. The battery level indi-
2
2
again for 3 seconds. The battery
2
3
flashes
(Figure ).
5 E
(Figure ).
6 D
while the travel lock