Troubleshooting - Scheppach bgs 700 Traducción De Las Instrucciones Originales

13. Troubleshooting

Problem
Motor doesn't start
Machine gets slower
during work.
Sanding belt comes off
the drive pulleys.
The wood gets burnt
during sanding.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible Cause
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
Too much pressure put on the work-
piece.
Belt does not run straight.
a) Sanding disc or belt covered with
grease.
b) Excessive pressure on workpiece.
Action
a-d) Replace all damaged parts before you use
your machine again.
e) Contact your local service centre. Every
attempt to carry out a repair, can be dangerous
if it is not done by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
a)Replace disc or belt.
b) Reduce pressure on workpiece.
GB | 25