Qc-Es(Edger Attachment) - Maruyama QC-E Manual Del Propietario U Operador

QC-ES (Edger Attachment)
Installing Debris Shield
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
debris shield in place.
Debris Shield
Hex Nut
Lock Washer
Flat Washer
Spacer
Plate Stud
1. Install the spacer onto the plate stud.
2. Install the shield onto the plate stud, making sure the
shield stud fits into the matching slot in the plate.
3. Install the flat washer, lock washer and hex nut onto
the plate stud.
4. Install the flat washer and knob onto the shield stud.
Shield Stud
Plate
Flat Washer
Installing Edger Blade
POTENTIAL HAZARD
• If the Edger blade is not adequately
tightened, it can come loose from the
Edger during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injury.
HOW TO AVOID THE HAZARD
• Make sure the Edger blade is securely
fastened to the attaching shaft in the
gearcase.
3 mm Hex Wrench
Blade Bolt
Knob
(left hand thread)
1. Install the boss adapter onto the scollar onto the
attaching shaft out of the gearcase.
2. Install the edger blade, clamping washer and blade
bolt.
Note: The blade bolt has left-hand threads.
3. Align the hole in the boss adapter with the hole in
the gearcase.
4. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the splined
shaft.
5. Tighten the blade bolt to 100 in.-lbs. (11.3 N·m).
6. Remove the 3 mm hex wrench from the boss
adapter and gearcase.
— US-11 —
CAUTION
Collar
Clamping Washer
Gearcase
Boss Adapter
Edger Blade